2.Choose the communication port through which the DXP is connected to the computer:

If you selected a Comm port, check the baud rate displayed in the Comm Port Selection window. To change the baud rate, click the Baud button to display the baud rate pop-up list. (After you click it, this button changes to OK.) Double-click on the desired baud rate (available rates are 9600, 19200, 38400, and 115200; the default is 9600), then click OK and proceed to step 4.

Figure 72. Baud Rate Pop-up List

If you selected IP [LAN], click OK and proceed to step 3.

If you selected Emulate, click OK and see “Using Emulation Mode” on page 99.

3.If you selected IP [LAN] in step 2, the IP Connection window opens.

Figure 73. Address and Password Entry for IP Connection

a.Check the Extron IP Address field in the IP Connection window. The field displays the last IP address entered.

If the IP address is correct: Proceed to step 3b.

If the address is not correct: Either click in the Extron IP Address field and

enter the IP address or click on the scroll down button () and select from among the recently used addresses.

NOTE: If your local system administrators have not changed the value, the factory-specified default address, 192.168.254.254, is the correct value for this field.

b.If the DXP is password protected, click in the Password field and enter the appropriate administrator or user password.

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Matrix Software

74

Page 80
Image 80
Extron electronic DXP DVI PRO manual Baud Rate Pop-up List