Extron electronic DXP DVI manual Example 8 Muting and Unmuting an Output, Clear All Selections

Example 8: Muting and Unmuting an Output

In the following example, several switcher outputs are muted and unmuted. The steps show the front panel indications that result from your actions.

1.Press and release the Esc button.

Press the Esc button to clear all selections.

C O N T R O L

ENTER PRESET VIEW ESC

The button blinks once.

Figure 54. Clear All Selections

2.Press and release the View button to enter view-only mode. The View button lights red.

3.To select both video and audio for viewing and muting, if necessary, press and release the Video and Audio buttons.

NOTE: This example shows the front panel indications if examples 1, 2, and 3 have been completed.

Press the Video button to toggle video on and off.

The button lights green when selected.

I / O

VIDEO AUDIO

Press the Audio button to toggle audio on and off.

The button lights red when selected.

Until you select an input, the buttons for all untied outputs light amber if no inputs are tied, green if no video inputs are tied (only audio is tied), or red if no audio inputs are tied (only video is tied).

			INPUTS
1	2	3	4	5	6	7	8

Figure 55. Select Audio Only

NOTE: Output mutes are protected when front panel lock mode 2 is selected. You can view the mutes in lock mode 2 but you cannot change them from the front panel (see “Locking and Unlocking the Front Panel (Executive Modes)” on page 39).

If front panel lock mode 2 is selected and you try to perform steps 4 and 5, the actions are ignored.

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation 37