Extron electronic DXP DVI PRO manual Reset Modes Summary, Activation, Result, Purpose/Notes

Reset Modes Summary

Mode	Activation	Result		Purpose/Notes
1	Hold in the Reset button while applying	Restores the factory-installed firmware. It		Mode 1 can be
	power to the switcher.	does not clear the current configuration.		used to remove a
				version of firmware
				if incompatibility
				issues arise.
3	Hold in the Reset button until	Turns events (such as on and off. During		Mode 3 is useful
	the Reset LED blinks once (after	resetting, the Reset LED blinks two times		for troubleshooting.
	approximately 3 seconds); then within	if events are starting or three times if
	1 second press Reset momentarily	events are stopping.
	(for less than 1 second) .
4	Hold in the Reset button until the	• Enables ARP capability (see .		Mode 4 enables
	Reset LED blinks twice (once after	• Sets the IP address, subnet address,		you to set
	approximately 3 seconds and again			IP address
			and gateway address to the factory
	after 6 seconds); then within 1 second			information using
			defaults.
	press Reset momentarily (for less than			ARP and the MAC
		• Sets port mapping to the factory
	1 second).			address.
			default.
				It does not replace
		•	Turns DHCP off.
				any user-installed
		•	Turn events off.
				firmware.
		The Reset LED blinks four times in quick
		succession during the reset.
5	Hold in the Reset button until the	Performs a complete reset to factory		Mode 5 is useful
	Reset LED blinks three times (once	defaults (with the exception of the		if you want to
	after approximately 3 seconds, again	firmware), which includes:		start over with
	after 6 seconds, and then again after	• Everything mode 4 does		configuration and
	9 seconds); then within 1 second			uploading and also
		• Reset of almost all real time
	press Reset momentarily (for less than			to replace events.
			adjustments:
	1 second).
			• Clears all ties, presets, audio or
			RS-232 mutes, and I/O grouping.
			• Resets all IP options.
			• Removes or clears all switcher files.
		The reset LED blinks four times in quick
		succession during the reset.
	NOTE: Mode 5 reset clears most adjustments. To save these settings, use the Matrix Switchers
	Control Program and select Save MATRIX settings as... from the File menu before you
	perform this reset (see the Matrix Switcher Control Program help file for more information).

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation 42