Extron electronic DXP DVI Configuration Port, Control Buttons, Secondary functions, Action, locks

Secondary functions (•):

•Select a global preset (see “Saving and Recalling Presets” on page 29).

•Output 1 only: With the Input 1 button, places the switcher in I/O grouping mode (see “I/O Grouping” on page 32).

•Mute and unmute an output (see “Muting and Unmuting Video and Audio Outputs” on page 36).

Configuration Port

CConfig port — This RS-232 port is an alternative to the Remote RS232/RS422 connector on the DXP rear panel (see “G Remote RS232/RS422 connector” on page 9 for a description). The port (RS-232 only) can be used for system configuration and control via SIS commands or the control software. To connect to the Config port, see “RS-232 Config port (front panel)” on page 11.

Control Buttons

The following table summarizes the primary and secondary functions of the four control buttons.

Primary Functions

	ENTER	PRESET	VIEW	ESC
Action:	Save changes.	Select preset	Select view	Cancel or
		mode.	mode.	escape.
Indication:	Blink: Save	Blink: Save preset.	View the selected	Blinks once.
	needed	Lit: Recall preset.	mode.

Secondary Functions

I/O Grouping	Action/	Select group 1.	Select group 2.	Select group 3.	Select group 4.
	indication:
	Action 1:	Select Configuration Mode
Port
	Action 2/	Select 9600 baud.	Select 19200 baud.	Select 38400	Select 115200
configuration
	indication:	Blink: Selected	Blink: Selected	baud.	baud.
				Blink: Selected	Blink: Selected
		With Video and
Front panel		Audio, select lock
	Action:	mode 2 or toggle
locks
		between modes 0
		and 2.

DEnter button — The Enter button does the following:

Primary functions (❏):

❏Saves changes that you make on the front panel.

❏Indicates that a potential tie has been created but not saved.

❏Indicates that a global preset has been selected to be saved or recalled but that the preset action has not been accomplished.

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation 15