Extron electronic DXP DVI PRO manual Resetting Using the Rear Panel Reset Button, System Reset

To reset the switcher to the factory default settings, press and hold the Video and Audio buttons while you apply AC power to the switcher.

NOTE: System reset does not reset the Internet protocol (IP) settings or replace user-installed firmware.

Press and hold the Video and Audio buttons while you apply power to the switcher.

I / O

The buttons flash, then become unlit.

VIDEO AUDIO

Continue to hold the Video and Audio	Power
buttons until all input and output buttons
return to either unlit or to background
illumination and the Video and Audio
buttons light.

Release the Video and Audio buttons.

Figure 61. System Reset

Resetting Using the Rear Panel Reset Button

The rear panel has a recessed Reset button that initiates various levels of resets. For different reset levels, press and hold the button while the switcher is running or press and hold the button while you apply power to the switcher. Use a pointed stylus, ballpoint pen, or small Philips screwdriver to press the button.

The table on the next page provides a summary of the reset modes.

ATTENTION: Review the reset modes carefully. Using the wrong reset mode could result in unintended loss of flash memory programming, port reassignment, or a controller reboot.

NOTES: • The reset modes listed in the table close all open IP and Telnet connections and all sockets.

•The modes described in the table below are separate functions, not a continuation from mode 1 to mode 5.

•There is no reset mode 2 for DXP.

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation 41