Extron electronic DXP DVI PRO manual Resetting, Switching from Lock Mode 1 to Lock Mode

Selecting Lock Mode 2 or Toggling Between Mode 2 and Mode 1

NOTES: • If the switcher is in lock mode 0 or mode 1, this procedure selects mode 2.

•If the switcher is in lock mode 2, this procedure selects mode 1.

Toggle the lock on and off by pressing and holding the Video and Audio buttons until the following buttons blink twice (approximately 2 seconds).

•The Esc, Video, and Audio buttons blink twice if the DXP is now in lock mode 2.

•The Video and Audio buttons blink twice if the DXP is now in lock mode 1.

Press and hold the Video and Audio buttons simultaneously to enable lock mode 2 or to toggle between mode 1 and mode 2.

I / O

VIDEO AUDIO	2 seconds
	ESC
	>

I / O

VIDEO AUDIO

The Esc, Video, and Audio buttons blink twice to indicate mode 2.

The Video and Audio buttons blink twice to indicate mode 1.

Release the buttons.

Figure 60. Toggle Front Panel Lock Between Mode 2 and Mode 1

Switching from Lock Mode 1 to Lock Mode 0

If the switcher is in lock mode 1, you cannot change it directly to lock mode 0 (completely unlocked). You must first place the switcher in lock mode 2, then toggle it to mode 0 (see “Selecting Lock Mode 2 or Toggling Between Mode 2 and Mode 0” on the previous page).

Resetting

There are several methods by which you can reset the DXP, and some of these methods allow for four levels of resetting. The following reset methods are available on the DXP:

•Front panel buttons (See “Resetting the System from the Front Panel.”)

•Rear panel Reset button (See “Resetting Using the Rear Panel Reset Button” on the next page.)

•SIS commands (See the Resets commands in the Command and Response Table for SIS Commands, page 64.)

•Matrix Switchers Control Software (See “Master-Reset button” on page 98.)

Resetting the System from the Front Panel

The front panel reset is identical to the E ZXXX} SIS command (see the Reset whole switcher command in the Command and Response Table for SIS Commands, page 64.) A system reset does the following:

•Clears all ties and presets

•Clears all video and audio mutes

•Clears all I/O grouping

NOTE: The system reset clears most image and audio adjustments. If you want to save these settings, use the Matrix Switchers Control Program and select Save MATRIX settings as... from the File menu before you perform this reset (see the “Matrix Software” section, beginning on page 72).

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation 40