Fortinet 100 user manual Adding an address group, 209

PPTP and L2TP VPN Configuring the FortiGate unit as a PPTP gateway

Figure 30: Example PPTP Range configuration

Adding a source address

Add a source address for every address in the PPTP address range.

1Go to Firewall > Address.

2Select the interface to which PPTP clients connect.

3Select New to add an address.

4Enter the Address Name, IP Address, and NetMask for an address in the PPTP address range.

5Select OK to save the source address.

6Repeat for all addresses in the PPTP address range.

Note: If the PPTP address range is comprised of an entire subnet, add an address for this subnet. Do not add an address group.

Adding an address group

Organize the source addresses into an address group.

1Go to Firewall > Address > Group.

2Add a new address group to the interface to which PPTP clients connect.

3Enter a Group Name to identify the address group.

The name can contain numbers (0-9), uppercase and lowercase letters (A-Z, a-z), and the special characters - and _. Other special characters and spaces are not allowed.

4To add addresses to the address group, select an address from the Available Addresses list and select the right arrow to add it to the Members list.

5To remove addresses from the address group, select an address from the Members list and select the left arrow to remove it from the group.

Select OK to add the address group.

FortiGate-100 Installation and Configuration Guide 209