Model D2424 Reference Manual (Punch In/Out)

Auto Punch In/Out Take

After you are satisfied with your rehearsal, you can proceed to an actual take of Auto Punch In/Out.

You can undo or redo Auto Punch In/Out recording if you change your mind. The control panel settings are the same as those for rehearsal.

1.Press the [RECORD TRACK] select key [3/11/19] to set track 3 to READY.

2.Locate a point slightly before the Auto Punch In point.

3.Confirm that Auto Punch mode is turned on.

Press the [AUTO PUNCH] key to turn on the function, if it is not already on (REHEARSAL/TAKE LED flashes).

4. Press the [RECORD] button while holding down the [PLAY] button.

Only TAKE LED (red) lights up and starts TAKE.

AUTO

PUNCH

REHEARSAL

 

 

TAKE

Start point of

Auto Punch In point

Auto Punch Out point

End point of

playback

(Take In)

(Take Out)

playback

Track 8

 

 

Track 7

 

 

Track 6

 

 

Track 5

 

 

Track 4

 

 

Track 3

This part is changed.

 

Track 2

 

 

Track 1

 

 

All tracks are in

Only track 3 in input

All tracks are in

playback monitoring

monitoring.

playback monitoring

mode.

The sound is not recorded to

mode.

 

this time. The RECORD

 

 

button lamp flashes.

 

 

 

 

 

 

 

 

 

 

The recorder punches out

The recorder punches in

automatically at the Punch

automatically at the Punch

In point.

Out point.

Track 3 indication on the display will only light up between the AUTO PUNCH IN/OUT point, and will flash in any other case.

When the Auto Punch Out point is passed, the recorder cancels Auto Punch mode automatically, and nothing appears in the A. PUNCH display area.

<Caution after Punch Out>

At “Take” of punch out, the punch-in recording track will not immediately enter the repro monitor mode from the input monitor mode enter the repro monitor mode about two seconds after mute playback. This is a functional feature of recorder and not a malfunction.

5.When you finish recording, press the [STOP] button.

6. Play track 3 to check the result of the Auto Punch In/Out operation.

If you fail with AUTO PUNCH IN/OUT and are not satisfied, repeat the process by performing the AUTO PUNCH IN/OUT undo operations described in the next section.

Single Undo/Redo

You can single undo or redo Auto Punch In/ Out recording.

Press the [UNDO/REDO] key after recording is complete to restore the conditions that existed prior to the recording.

Press the [UNDO/REDO] key again to restore the conditions that existed after the recording.

However, the procedures explained here is for Single Undo/Redo and there are limitations as written in the Notes below. If the current drive was formatted with the multiple undo function ON, Multiple Undo is also possible.

Refer to page “64” for details on the Multiple Undo function.

<Notes at executing sigle undo/redo>

Note-1: This function only works when this recorder is in the stop mode.

Note-2: After finishing auto punch in/out, please note that single Undo/Redo is not possible if the following have been executed.

If a new recording has been made.

When a new editing job is executed (such as Copy & Paste, Move & Paste, or Erase).

When in the AUTO PUNCH ON mode, when the AUTO PUNCH IN point is passed in the PLAY (or RECORD) mode.

If the power was switched off.

If program select was executed.

When multiple undo is executed.

41

Page 41
Image 41
Fostex D2424 manual Auto Punch In/Out Take, Press the Record button while holding down the Play button