Fostex D2424 manual Copy & Paste between programs

Model D2424 Reference Manual (Editing Tracks)

Copy & Paste between programs

Copy & Paste between programs can be performed using the procedures below in the same manner as in the previous “Copy & Paste in the same program.”

1.

2.

Store the copy (or move) start point (CLIPBOARD IN point), end point (CLIPBOARD OUT point), and the paste start point (AUTO PUNCH IN point).

Check the stored edit points using the Preview function and make adjustments if necessary.

3.

Specify the track to be copied and copy it in the clipboard (Copy Clip).

4. Switch to program for pasting using the program select function.

5.

6.

7.

Register the copy starting point (AUTO PUNCH IN point) in the switched program.

Check the registered editing point with the “Preview function” and if necessary, correct the editing point.

In the same way as before, enter the editing mode by pressing the [EDIT] key. “Copy Paste?” will be displayed after pressing the [EDIT] key.

8. Next, specify the track and amount to be pasted and execute paste.

Checking the clipboard data

Data copied to the clipboard can be confirmed even after switching the program by the above procedure.

For example, when a specific data in Program 1 is copied to the clipboard and then switched to Program 2 in which it is to be pasted, as mentioned before, if the [PLAY] button is pressed while pressing on the [STOP] button, you can listen to data copied in Program 1 (clipboard play).

During clipboard play, “P01” will appear in the display to indicate that copy data in Program 1 is being played back.

69