Fostex D2424 manual Manual Punch In/Out take, Single Undo/Redo, Hint

Model D2424 Reference Manual (Punch In/Out)

Manual Punch In/Out take

You can proceed to record if you are satisfied with the recording level, foot switch timing, and rehearsal.

<Note>

You cannot record a second take during the Manual Punch In/Out operation without stopping the recorder. That is, the recorder will continue playing after you finish recording a take, but you cannot record another take by pressing the foot switch.

1.Confirm that Rehearsal mode is cancelled, and start playing the recorder from a point slightly before the desired Punch In point.

2.Play the guitar, accompanying the playback of tracks 1 to 8.

3.Press the foot switch at the desired Punch In point. Press the foot switch again at the desired Punch Out point.

Start point of	Auto Punch In point	Auto Punch Out point	End point of
playback	(Take In)	(Take Out)	playback

Track 8
Track 7
Track 6
Track 5
Track 4
Track 3	This part is changed.
Track 2
Track 1
All tracks are in	Only track 3 in input	All tracks are in
playback monitoring	monitoring, and data will be	playback monitoring
mode.	recorded. The RECORD	mode.
	button lamp flashes.

Press the foot switch at the	Press the foot switch at the
Punch In point.	Punch Out point.

The recorder enters recording mode at the Punch In point, and cancels recording mode at the Punch Out point.

4.Press the [STOP] button.

5.Play track 3 and check the result of Punch In/Out.

<Caution after Punch Out>

At “Take” of punch out, the punch-in recording track will not immediately enter the repro monitor mode from the input monitor mode enter the repro monitor mode about two seconds after mute playback. This is a functional feature of the recorder and not a malfunction.

<Hint>

You can use the [PLAY] button and the [RECORD] button, instead of using the foot switch.

Follow the steps below.

This method also does not allow you to record another take unless you stop the recorder first. Procedure:

1.Press the [PLAY] button to start playback from a point slightly before the Punch In point.

2.Press the [RECORD] button while holding down the [PLAY] button at the desired Punch In point. (Punch In recording starts.)

3.Press the [PLAY] button at the desired Punch Out point. (Recording is punched out.)

•If you press only the [RECORD] button in both steps 2 and 3, you can rehearse Punch In/Out.

Single Undo/Redo

You can single undo or redo Manual Punch In/ Out recording.

Press the [UNDO/REDO] key after recording is complete to restore the conditions that existed prior to the recording.

Press the [UNDO/REDO] key again to restore the conditions that existed after the recording.

However, the procedures explained here is for Single Undo/Redo and there are limitations as written in the Notes below. If the current drive was formatted with the multiple undo function ON, Multiple Undo is also possible.

Refer to page “64” for details on the Multiple Undo function.

<Notes at executing sigle undo/redo>

Note-1: This function only works when this recorder is in the stop mode.

Note-2: After finishing manual punch in/out, please note that single Undo/Redo is not possible if the following have been executed.

•If a new recording has been made.

•When a new editing job is executed (such as Copy & Paste, Move & Paste, or Erase).

•When in the AUTO PUNCH ON mode, when the AUTO PUNCH IN point is passed in the PLAY (or RECORD) mode.

•If the power was switched off.

•If program select was executed.

•When multiple undo is executed.

43