Fostex D2424 manual Loading data saved on several removable disks

Model D2424 Reference Manual (Saving and Loading Song Data)

Loading data saved on several removable disks

As an example here, we will load the data of a Program saved onto two removable disks.

1.Insert the first disk (Disk-1) into the SCSI device.

<Note>

Make sure that you insert the disks in the correct order. If you insert the wrong disk, the recorder displays "Wrong disk" -> "Illegal No!" and ejects the disk. Follow the disk markings you made during the save operation.

2.Follow Steps 1-3 of the “Loading Song data” procedure.

The display flashes the number of the existing Backup data in the SCSI disk, and then indicates that the first disk has been inserted.

Flashing

SETUP

OL	OL	BIT	24
0	0
3	3		FS
6	6
9	9		kHz
12	12		CLOCK
18	18
24	24		INT
30	30
42	42
∞	∞

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

5.Insert Disk 2 (second disk) into the SCSI hard disk drive according to what the display requests.

Loading automatically resumes when Disk 2 is inserted.

The display will show the same count down as shown for Disk 1. The size of the program is counted down along with the load process.

When all data is loaded, “COMPLETED!” lights up, and the program time base (ABS 0) started up prior to going into the SETUP mode will appear.

<Note>

You cannot abort a load operation on a SCSI device while it is in progress.

6.Press the [EXIT/NO] key, or [STOP] button.

The “COMPLETED!” go off.

Rotating the [JOG] dial will toggle between “B**” and “Eject.” If you wish to cancel the load operation and remove the disk, select “Eject” and press the [EXECUTE/ YES] key.

3.Press the [EXECUTE/YES] key.

A prompt inquiring whether to set a new program on the current drive which is the load destination will appear. ("New PGM" appears and "SURE?" flashes.)

Flashing	Flashing
	SURE?
OL		OL	BIT	24
0	0
3	3			FS
6	6
9	9			kHz
12	12			CLOCK
18	18
24	24			INT
30	30
42	42
∞		∞

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Turning the [JOG] dial in this state makes it possible to select a program on the current drive. The size of the program appears when the program is selected.

If you select a program that is already recorded with data and load is executed for the load destination, the existing data is deleted while loading takes place.

If you do not want to overwrite the existing data, select “New PGM” mentioned above, prior to loading.

4.Press the [EXECUTE/YES] key after selecting the program.

Loading is started and the display will show “B** >> P**

***MB”. This indicates that the backup data (B**) on the SCSI hard disk is being loaded on the current drive program (P**).

The “***MB” (load size) is counted down as loading proceeds.

When Disk 1 loading is completed, an “Insert Disk 2” message appears, and Disk 1 is automatically ejected.

96