Fujitsu MBC2073RC, MBC2036RC, MBA3300RC, MBA3147RC, MBA3073RC specifications Init

6.1 Sense Data

Table 6.4 Additional Sense Code and Additional Sense Code Qualifier (3/6)

C*	Q*	Name	Explanation	Sense
				key
1C	01	Primary defect list not found	The defect list (P List) header is incorrect.	3
	02	Grown defect list not found	The defect list (G List) header is incorrect.	3
	80	SA information list not found	The SA information (MODE SELECT parameter) header is	3
			incorrect.
1D	00	Miscompare during verify	Comparison of data transferred from the INIT by a VERIFY	E
		operation	command (when the Byte Check mode was specified) with data
			read from the disk media was terminated unsuccessfully.
	80	Miscompare during self-	There is an unmatch to compare read data with write data during	E
		configuration	self-configuration.
1F	00	Partial Defect List Transfer	Read Defect Data command (37h) cannot transfer all the Defect	1
			data in the target because the numbers of defect exceeded the
			maximum.
20	00	Invalid command operation	CDB byte 0 (operation code) is illegal.	5
		code
21	00	Logical block address out of	A logical block address which exceeds the drive's maximum	5
		range	value was specified.
24	00	Invalid field in CDB	There is an error in a specification in the CDB.	5
25	00	Logical unit not supported	An illegal LUN was specified.	5
26	00	Invalid field in parameter list	There is an error in the parameter list specifications transferred	5
			from the INIT during command execution.
27	00	Write protected	A write operation was attempted in a write protected area. Or a	7
			write operation is prohibited at the external operation panel.
29	01	Power on occurred	Microcode was downloaded immediately after power on.	6
	02	SCSI Bus Reset Occurred	A HARD_RESET primitive was received.	6
	03	TARGET RESET function	A Logical Unit RESET was received.	6
		occurred
	04	Firmware Internal Reboot	Reboot occurred in the firmware	6
	07	I_T Nexus Loss occurred	I_T Nexus Loss Time (Mode Page 19) was expired.	6
2A	01	Mode parameter changed	The MODE SELECT parameter values were changed by another INIT.	6
	03	Reservations preempted	A persistent reserve state was cleared by another INIT.	6
	04	Reservations released	A persistent reserve state was released	6
	05	Registrations preempted	A persistent reserve state was preempted by another INIT.	6
2F	00	Command cleared by another	A command was forcibly terminated by another INIT during	6
		INIT	execution or queuing.
			∙ By a CLEAR TASK SET
			∙ The sense hold state was entered when the QErr bit was set on
			"1."
		* C: Additional Sense Code, Q: Additional Sense Code Qualifier

C141-C013 367