Fujitsu MBA3147RC, MBC2036RC, MBC2073RC, MBA3300RC, MBA3073RC specifications Parameter Data Format

Parameter Data Format

c.TB (transfer block)

"1": Data blocks which contain errors that are impossible to correct are transferred to the INIT during a read operation.

"0": Data blocks which contain errors that are impossible to correct are not transferred to the INIT during a read operation.

d.RC (read continuous)

This bit specifies continuous transfer of all the data requested by a command unaccompanied by a delay for executing error recovery processing.

The HDD disregards the specification in this bit and operates according to the default value (=0).

e.EER (enable early recovery)

"1": When a correctable data check has been detected, data correction according to the ECC is applied immediately without executing retry (rereading) up to the number of times specified in the "Number of retries during READ" parameter.

"0": When a correctable data check has been detected, retry (rereading) is executed up to the number of times specified in the "Number of retries during READ" parameter, then data correction according to the ECC is applied if possible.

The HDD disregards this bit and operates according to the default value (=1).

f.PER (post error)

"1": When several errors (errors related to the disk drive), which were recovered from normally through the HDD's error recovery processing, have been detected, a CHECK CONDITION status is reported when execution of that command is completed. In the sense data generated at this time, the sense key indicates "RECOVERED ERROR [=1]" and the content of the final error to be corrected successfully is reported.

"0": Even when several errors (errors related to the disk drive), which were recovered from normally through the HDD's error recovery processing, have been detected, that command is completed with a GOOD status and the contents of the recovered errors are not reported.

g.DTE (disable transfer on error)

"1": Even when several errors on the disk drive, which were recovered from normally through the HDD's error recovery processing, have been detected, execution of that command terminates at that point.

"0": When several errors on the disk drive, which were recovered from normally through the HDD's error recovery processing, have been detected, execution of that command is continued.

The HDD disregards this bit and operates according to the default value (=0).

284 C141-C013