Fujitsu MBC2036RC, MBC2073RC, MBA3300RC, MBA3147RC, MBA3073RC Sense Data and Error Recovery Methods

Sense Data and Error Recovery Methods

Table 6.4 Additional Sense Code and Additional Sense Code Qualifier (2/6)

C*	Q*	Name	Explanation	Sense
				key
0E	01	Information Unit Too Short	The received write data is shorter than the stipulated length.	B
	02	Information Unit Too Long	The received write data is longer than the stipulated length.	B
11	01	Read retries exhausted	Unrecovered error was detected during data read (retry out).	3, B
	02	Error too long to correct	Unrecovered error was detected during data read (BCRC error	3, B
			detected by SAS/IF)
13	00	Sync Mark not found for Data	SM (Sync Mark) could not be detected in the Data area.	1, 3, B
		field
14	00	Record entity not found	Expected data from a sector was undetected. (LBA compare	1, 3, B
			error detected by FMT)
	01	Record not found	The target data block (sector) could not be detected.	1, 3, B
15	01	Mechanical positioning Error	A seek error occurred in the drive.	1, 3, B
	02	Positioning Error detected by	LBA did not match due to Cylinder number's mismatch.	1, 3, B
		read of medium
17	01	Recovered data with retries	A data error was recovered from by reading was retried.	1
	02	Recovered data with positive	A data error was recovered by read retry with offsetting head to	1
		head offset	positive direction.
	03	Recovered data with negative	A data error was recovered by read retry with offsetting head to	1
		head offset	negative direction.
	06	Recovered data without ECC:	Automatic alternate allocation was applied without ECC	1
		data auto-reallocated	correcting a data error.
18	00	Recovered Data with Error	A data error was recovered by read retry with ECC correcting.	1
		Correction Applied
	07	Recovered data without ECC:	Rewriting to the same sector was performed without ECC	1
		recommended rewrite	correcting a data error.
19	02	Defect list error in primary list	An error was detected during reading of the defect list (P List).	3
	03	Defect list error in grown list	An error was detected during reading of the defect list (G List).	3
	80	Log information read error	An error was detected during reading of statistical information.	3
	81	Log information write error	A write error was detected during writing of statistical	3
			information.
	84	Mode Select SA write Error	An error was detected during writing of SA information (Mode	3
			Select Parameter)
	Ax	Drive Parameter SA write	An error was detected during writing of SA information (Device	3
		Error	Information)
	Bx	Drive Parameter SA write	An error was detected during writing of SA information (Device	3
		Error	Information)
1A	00	Parameter list length error	There is a mistake in the indication of the parameter list page	5
			length.
		* C: Additional Sense Code, Q: Additional Sense Code Qualifier

366 C141-C013