Garmin HM210DP/DI manual Telecom Approval, FCC Part 68 Statement

Important Information

15.3.4Telecom Approval

The HM210dp/di is approved according to the following telecom standard: FCC Part 68

15.3.4.1FCC Part 68 Statement

The Federal Communications Commission (FCC) has established Rules which permit this device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on party lines or coin phones.

If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until repair has been made. If this is not done, the telephone company may temporarily disconnect service.

The telephone company may make changes in its technical operations and procedures; if such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the changes. You will be advised of your right to file a complaint with the FCC.

If the telephone company requests information on what equipment is connected to their lines, inform them of:

The telephone number to which this unit is connected

The USOC jack required

The FCC Registration Number (indicated on the label).

The Ringer Equivalence Number (REN). Note that if several devices are connected on the same line, the RENs must not add up to more than 5.0. This REN figure is important to your telco and can be found on the equipment’s FCC compliance label.

In case of operational problems, disconnect your unit by removing the modular or multi-connector plug from the telco’s jack. If your regular phone still works properly, your modem has a problem and must remain disconnected and (officially) serviced or returned for repairs. If upon the above disconnection your regular phone still has problems, notify your telco that they may have a problem. If problem is still found in premises wiring not telco-installed, you are subject to a service charge. If a fault is found in telco-installed wiring, you may still be subject to a service call charge.

Unless otherwise noted in the User’s Manual (e.g. fuses, etc), user may not under any circumstances (in or out of warranty) attempt any service adjustment, or repairs on this unit. It must be returned to the factory or

EN/LZT 108 6492 R2 - October 2003 115