Garmin HM210DP/DI manual Select an ATM VC interface previously created, e.g. aal5-0

Basic Configuration

Lower Interface:

Conf. IP Address: Netmask:

Use DHCP:

Default Route:

Gateway IP Address:

(such as a company’s public Web server). Packets incoming on a DMZ interface – whether from a LAN or external source – are subject to a set of protections that is in between public and private interfaces in terms of restrictiveness.

Select an ATM VC interface previously created, e.g. aal5-0.

EoA interfaces are defined in software, and then associated with lower-level software and hardware structures (at the lowest level, they are associated with a physical port – the WAN port). This field should reflect an interface name defined in the next lower level of software over which the EoA interface will operate.

0.0.0.0 / 0.0.0.0

To use the HM210dp/di as a bridge, you don’t need to set the IP address and subnet mask. Just keep the default.

Enable / Disable

When Enabled, this setting instructs the device to accept IP information assigned dynamically by your ISP’s DHCP server. If the interface will be used for bridging with your ISP and you will not be routing data through it, leave this checkbox unselected.

Enable / Disable

Indicates whether the HM210dp/di uses the IP address assigned to this interface, if any, as its default route for your LAN. Your system can have only one default route.

The external IP address that the HM210dp/di communicates with via the EoA interface to gain access to the Internet. This is typically an ISP server.

4.After entering the fields above, click the Submit button and when the confirmation page appears, click Close.

5.You will return to the EoA Configuration page and see the newly added EoA interface:

EN/LZT 108 6492 R2 - October 2003 31