Configuring NAT
2.In the ”Rule Flavor:” dropdown list, select RDR.
3.In the “Rule ID:” field, enter an ID for the rule.
The Rule ID determines the order in which the rules are invoked (the lowest numbered rule is invoked first, and so on). In some case, two or more rules may be fined to act on the same set of IP addresses. Once a data packet matches a rule, the data is acted upon according to that rule and is not subjected to
4.From the “IF Name:” dropdown list, select the interface on the HM210dp/di to which this rule applies.
Typically, NAT rules apply to communication between your LAN and the Internet. Because the device uses the WAN interface (named
5.Select a “Protocol:” to which this rule applies, or select ALL if the rule applies to all data.
6.In the “Local Address From/To:” fields, type the same private IP address, or the lowest and highest IP addresses in a range:
If you type the same IP address in both fields, incoming traffic that matches the criteria of this rule will be redirected to that IP address. If you type a range of IP addresses, incoming traffic will be redirected to any available computer in that range. This option
EN/LZT 108 6492 R2 - October 2003 | 61 |
