Chapter 2: Installing and Setting Up your Autoloader

www.gateway.com

Installation in a .375 square-hole rack

To install the rail in a .375 square-hole rack:

1Identify the correct mounting holes on the vertical rail, making sure that the selected holes are on the same level as the mounting holes on the other three vertical rails.

Autoloader tab (autoloader not shown)

Vertical rail

10-32 inside

 

 

nut plate

Rail

Front coverassembly plate

2Mount the front cover plate to the vertical rail in the identified holes by using 10-32 x .625 bolts in the center two holes of the plate.

3Install the chassis into the rack by aligning the chassis-mounted rails with the mounted rail assemblies, then pushing the chassis into the rack.

4Secure the chassis into the rack by bolting the autoloader tabs to the upper and lower holes in the front cover plate using 10-32 x .625 bolts.

16