
CHAPTER 3: Operating your Autoloader | www.gateway.com |
3From the Autoloader submenu, scroll to Status, then press Enter. A list of messages similar to the following appears:
Status | Message | Description |
|
|
|
Magazines | L=* | The left magazine is present. |
|
|
|
| R=* | The right magazine is present. |
|
|
|
SCSI ID | A digit 0 through 15 | The assigned SCSI ID for the autoloader. |
| (default 5) |
|
|
|
|
Mode | Random | The change mode is set to Random. |
|
|
|
| SEQUENTIAL | The change mode is set to Sequential. |
|
|
|
BC Reader | Yes or No | A bar code reader is present. |
|
|
|
Viewing the firmware version
To view the current firmware version:
1From the Main menu, scroll to Status, then press ENTER. The Status submenu opens.
2Scroll to Autoloader, then press ENTER. The Autoloader submenu opens.
3Scroll to Version, then press ENTER. A list of messages appears on the LCD. The firmware version is listed as Firmware: VX.XX (where X.XX is the current installed version of the firmware).
Field | Description |
|
|
Firmware | The number indicates the firmware version. |
|
|
EDC | The number indicates the Error Correction Code that was generated |
| when the firmware was installed. The autoloader uses this number to |
| make sure that the firmware and the memory holding the firmware |
| are good. |
|
|
HW Rev | The number indicates the hardware version. |
|
|
ME Rev | The number indicates the mechanical version. |
|
|
48