
www.gateway.com
Caution
Be careful not to turn the knobs on the side of the magazine (see “Manually operating the magazine” on page 45) while the magazine is partially inserted into the autoloader. Doing so may cause damage to the magazine or the autoloader.
Using magazines and magazine blanks
The magazine is correctly installed when you feel it click into place and the front is flush with the front panel. “Left Mag Inserted” or “Right Mag Inserted” appears on the LCD. The autoloader automatically proceeds to run an inventory.
Installing a magazine blank
Caution
The magazine blank is correctly installed when you feel it click into place and the front of the blank is flush with the front panel of the autoloader.
To install a magazine blank:
1Grasp the magazine blank by the handle with one hand and guide the blank into the magazine bay.
2Slide the magazine blank into the magazine bay until it stops.
Removing a magazine
In most cases, you can remove a magazine by using the Eject command on the front panel menu. If you need to remove the magazine when the autoloader is powered off, you must remove it manually. Contact Customer Care (see “Getting Help” on page 6) for more information.
To remove a magazine using the front panel:
1On the menu, scroll to Commands, then press ENTER. The Commands submenu opens.
2Scroll to Eject, then press ENTER. The Eject submenu opens.
3Scroll to Right Magazine or Left Magazine, depending on which magazine you want to eject, then press ENTER.
The magazine pops forward so that the front of the magazine is no longer flush with the front panel.
4With one hand, grasp the magazine by the handle and slide it forward to remove. Place your other hand under the magazine to support it and prevent it from falling.
Removing a magazine blank
Your autoloader comes equipped with either two magazines, or one magazine and one magazine blank. The autoloader does not function without both magazine bays equipped with either a magazine or a magazine blank.
43