www.gateway.com

Returning the autoloader for service

Packing the autoloader

Use the original packing material to pack the autoloader: the shipping container, two foam insert packing pieces, the accessory kit box (or the filler tube if your autoloader did not come with an accessory kit box), and the antistatic bag. You will also need packing tape.

Important

One end of the foam insert has a curved piece. This end of the foam insert is designed to fit the front of the autoloader.

To pack the autoloader:

1Place the antistatic bag over the autoloader.

2Place a foam endcap on each side of the autoloader, then make sure that the pieces fit snugly onto the autoloader.

3Place the autoloader down into the shipping box and push the back of the autoloader towards the back end of the box.

4Insert the empty accessory kit box (or filler tube) into the shipping box at the front end of the autoloader in the space between the autoloader foam inserts and the shipping container.

5Place any necessary paperwork on top of the autoloader inside the box.

6Close and seal the box.

7Place the shipping label on the box.

85