www.gateway.com

Installation

Installation in a .280 Diameter thru-hole rack

To install the rail in a .280 diameter thru-hole rack:

1Identify the correct mounting holes on the vertical rail, making sure that the selected holes are on the same level.

Vertical rail

10-32 inside

nut plate

 

Front cover

Autoloader tab plate (autoloader not

shown)

Rail assembly

Important

The upper and lower tabs of the inside plate do not enter the holes of the rack.

They deform when secured.

2Mount the front cover plate to the vertical rail in the identified holes by using M6 (.200”) threaded bolts in the center two holes of the plate.

3Install the chassis into the rack by aligning the chassis-mounted rails with the mounted rail assemblies, then pushing the chassis into the rack.

4Secure the chassis into the rack by bolting the autoloader tabs to the upper and lower holes in the front cover plate using M6 (.200”) threaded bolts.

17