
www.gateway.com | Using magazines and magazine blanks |
To change the orientation of a magazine or magazine blank:
1Remove the magazine or magazine blank from the autoloader, if it is installed.
2Remove the two screws that attach the handle to the front of the magazine or magazine blank.
Screws
3Unsnap the handle carefully, being careful not to break the hinge.
4Rotate the magazine or magazine blank 180 degrees so that what was the front of the magazine is now the back.
5Attach the appropriate left or right handle to the front of the rotated magazine or magazine blank by snapping the handle onto the front of the magazine or magazine blank.
6Install the two screws to attach the handle securely to the magazine or magazine blank.
Manually operating the magazine
Caution
We recommend that you fully remove the magazine to load and unload cartridges.
Damage to the magazine or the cartridge could result if you rotate the magazine before it is fully removed.
There are two knobs on the side of the magazine opposite the side with the cartridge slots, one on each end. You can move the slots within the magazine by turning these two knobs and aligning a slot with one of the two openings. You can use the openings in the magazine to load and unload cartridges from the eight slots within each magazine.
45