Graco 332564B Color Change, Single Color Systems, Multiple Color Systems

Color Change

Color Change Module Kits are available as an accessory. See manual 333282 for complete information.

Single Color Systems

1.Follow the procedure under Flush the System, page 23.

2.Load the new color. See

Prime and Fill the System, page 20.

3.Command the system to Mix to start spraying.

Color Change

Multiple Color Systems

1.Command the system to Standby.

2.Enable manual override on System Screen 5, page 71.

3.Select the new recipe on the

Spray Screen, page 62. This will change colors in the pump and initiate a gun purge.

4.The system will purge material B then material A out of the gun. Each material will purge for the amount of time designated by the Flush Sequence selected for each material on the Recipe Screen, page 72.

5.Wait for the color change to complete. The system automatically goes from Color Change to Mix Fill and the remote mix manifold automatically selects the correct color.

6.Trigger the gun to complete the Mix Fill.

NOTE: There is a 10 second delay without flow before the system will fault.

7.Wait for the system to complete the Mix Fill operation. Command the system to Mix and begin spraying..

332564B 87