Graco 332564B important safety instructions Spray Screen, in Standby Mode

Run Mode Screens

Spray Screen

NOTE: In normal operating mode, controlled by a PLC, the Spray Screen is display only. No changes can be made. This section provides information about the Spray Screen if manual override is enabled on System Screen 5, page 71. The screens show a system in manual override mode.

The Spray screen includes the following information:

•Active Recipe (can be changed on this screen)

•Target Ratio

•Actual Ratio

•Target Pressure (if Pressure Mode is selected on System Screen 5) or Target Flow (if Flow Mode is selected). Target pressure or flow can be changed on this screen).

•Actual Pressure

•Actual Flow

•Potlife Remaining

•Gun Animation

In addition, the Spray screen includes three soft keys:

Press to put the system in

Standby.

Press to spray mixed material.

Press to purge the gun.

Figure 16 Spray Screen, in Standby Mode

Figure 17 Spray Screen, in Mix Mode

Figure 18 Spray Screen, in Idle Mode

62 332564B