Hitachi HCX5000I manual Bridged Caps to Create a

CHAPTER 1: ABOUT YOUR SELECSET 500A BRIDGED CAPS TO CREATE A

5Press the <CONF> key again to join the two CAPs or: To transfer the call to the caller on CAP1 press <JOIN>. You are out of the conference once you press the <JOIN> key.

If your system administrator has set up your phone system with the multiparty conference capability, you can place a conference on hold after connecting the two parties on CAP 1 and CAP 2. You can then take another call by pressing the <HOLD> key.

Both the CAP key with the conference and the <CONF> key flash slowly. At least one of these conferenced members should be an internal party to prevent trunk-to-trunk lockup.

Otherwise, remove yourself from the conference if an incoming internal caller is connected with an outside caller.

Note: If three CAPs are busy, you cannot use CAP 4 to initiate a conference or to join or bridge two parties.

6To disconnect the last party from the conference (the caller on CAP1), press the <DISC> key.

HCXTD840, Issue 1, July 2001 1-49