Hitachi L2002 Output Terminal Configuration

3–54

“C” Group: Intelligent Terminal Functions

Configuring Drive Parameters

Output Terminal Configuration

The inverter provides configuration for logic (discrete) and analog outputs, shown in the table below.

		“C” Function		Run		Defaults
				Mode
Func.	Name /				–FE(F)	–FU
			Description	Edit			Units
Code	SRW Display			Lo Hi	(EU)	(USA)
C021	Terminal [11] function			✘ ✘	01	01	—
					[FA1]	[FA1]
	OUT-TM 11	FA1
C022	Terminal [12] function		11 programmable functions	✘ ✘	00	00	—
					[RUN]	[RUN]
	OUT-TM 12	RUN	available for logic (discrete)
			outputs (see next section)
C026	Alarm relay terminal			✘ ✘	05	05	—
	function				[AL]	[AL]
	OUT-TM RY	AL
C028	[AM] signal selection		Two available functions:	✘ ✔	00	00	—
			00... Actual motor speed		output	output
	AM-KIND	F
			01... Motor current		freq.	freq.
			(see after next section)

The output logic convention is programmable for terminals [11], [12], and the alarm relay terminals. The open-collector output terminals [11] and [12] default to normally open (active low), but you can select normally closed (active high) for these terminals in order to invert the sense of the logic. You can invert the logical sense of the alarm relay output as well.

	“C” Function			Run		Defaults
				Mode
Func.	Name /				–FE(F)	–FU
			Description	Edit			Units
Code	SRW Display			Lo Hi	(EU)	(USA)
C031	Terminal [11] active		Select logic convention, two	✘ ✘	00	00	—
	state		option codes:
			00... normally open (NO)
	O/C-11	NO
			01... normally closed (NC)
C032	Terminal [12] active		Select logic convention, two	✘ ✘	00	00	—
	state		option codes:
			00... normally open (NO)
	O/C-12	NO
			01... normally closed (NC)
C036	Alarm relay active	state	Select logic convention, two	✘ ✘	01	01	—
			option codes:
	O/C-RY	NC
			00... normally open (NO)
			01... normally closed (NC)