Honeywell HRHD 410 manual Load Default Setup, Clear All Data

Configuration

Caution Do not use poor quality CD-R or CD-RW discs or ones that have been scratched or damaged in any way.

Caution Do not disconnect the USB cable or the power from the external drive while copying video clips. If the external drive is shut down or the USB cable is disconnected while copying video clips, the

DVR system may not work normally or the external drive could be damaged, and you will get an error message the next time you try to copy. You will need to power down the DVR and restart it to get rid of the error message. After the file system of the USB-IDE hard disk drive has been corrupted, this error message cannot be dismissed. Even after restarting the DVR it may automatically restart while preparing a backup. You must recover the file system using the recovery program, or you must reformat the hard disk drive.

Load Default Setup

Highlighting and selecting Load Default Setup (MENU ➤ Config ➤ Load Default Setup) brings up a screen asking you if you really want to load default settings and confirm it with a password.

Note Loading the Default Setup will not change the current time, time zone, daylight saving time, or network settings.

Clear All Data

Highlighting and selecting Clear All Data (MENU ➤ Config ➤ Clear All Data) brings up a screen asking you if you really want to clear all data and to confirm it with a password.

Caution Selecting Clear All Data will erase all recorded video.

Rev 3.01	74	Document 900.0315
		10/05