Honeywell HRXD16, HRXD9 manual Turning on the Power, Initial Unit Setup

Configuration
	Table 3-1	Front Panel Buttons and Controls (cont’d)
Control	Description
Jog Dial	When in playback mode, you can play video forward image-by-image by
	turning the Jog Dial clockwise and backward image-by-image by turning the
	Jog Dial counterclockwise.
	When in PIP mode, you can make the PIP screen smaller by turning the Jog Dial
	clockwise and larger by turning the Jog Dial counterclockwise.
	When in Setup mode, you can change number values by highlighting the item
	in the menu and turning Jog Dial clockwise or counterclockwise to increase or
	decrease the number.
ID Button on	If a DVR System ID is set to 0, the infrared remote control will control that DVR
Remote Control	without any additional operations. (Refer to Figure 3-6, Information Screen, in
	this chapter for further information on setting the System ID.) If the system ID is

1 to 16, you must to press the ID button on the remote control and then press the corresponding number button (1 to 16) in order to control that DVR. If the System ID of two or more DVRs is set to 0, those DVRs will react to the infrared remote control at the same time.

Turning on the Power

Connecting the power cord to the DVR turns on the unit. The unit takes approximately 60 seconds to initialize.

Initial Unit Setup

Before using your DVR for the first time, you will want to establish the initial settings. This includes settings such as time and date, display language, camera, audio, remote control, record mode, network and password. Your DVR can be set up using various screens and dialog boxes.

Throughout the screens you will see . Highlighting and pressing gives you the opportunity to reset that screen to its default settings.

Press MENU to enter the setup screens. The Login screen appears.

Document 900.0856 Rev B	37
02/08