Configuration
Note You can use the domain name instead of IP address if you already set up the DNS Server when setting up the LAN.
4.Highlight the box beside Port and press 
. Set the port number of the DVRNS server using the Up and Down arrow buttons to increase or decrease the numbers.
5.Highlight Use NAT and press 
to toggle between On and Off.
Note When using the NAT (Network Address Translation) device, refer to the NAT manufacturer’s instructions for the proper network settings.
6.Highlight the box beside DVR Name and press 
. A virtual keyboard appears allowing you to enter the DVR name to be registered on the DVRNS server.
7.Highlight the Check box and press 
to check whether or not the name you entered can be used.
Note The DVR name you entered should be checked by selecting
Check, otherwise the DVRNS changes will not be saved.
Note When entering no name or a name already registered on the
DVRNS server, an error message displays.
8.Highlighting Save and pressing 
registers the DVR on the DVRNS server. Proper DVRNS settings will display the help desk information of the DVRNS server in the box beside Help Desk.
WebGuard Setup
1.Highlight the WebGuard tab, and the WebGuard screen (Figure
58
