Honeywell HRXD16, HRXD9 manual Connecting to the Network Port, Network Connector

Installation

Caution Do NOT connect or disconnect SCSI devices while the DVR power is on. The DVR must be powered down to connect or disconnect SCSI devices. Power up SCSI devices so they are ready for operation before powering up the DVR. Power down SCSI devices after powering down the DVR and then disconnect SCSI devices.

Caution If the SCSI device is shut down while the device is operating, the

DVR system might not operate normally.

Connecting to the Network Port

Figure 2-15 Network Connector

The DVR can be networked using the 10/100Mb Ethernet connector. Connect a Cat5 cable with an RJ-45 jack to the DVR connector. The DVR can be networked with a computer for remote monitoring, searching, configuration and software upgrades. See Chapter 3, Configuration for configuring the Ethernet connections.

Caution The network connecter is not designed to be connected with cable or wire intended for outdoor use.

Document 900.0856 Rev B	29
02/08