General HP JetDirect information

 

 

Message

Description

 

 

Status

The current state of the print server:

 

I/O Card Ready: The print server has successfully connected

 

to the network and is waiting for data.

 

I/O Card Initializing: The print server is initializing the

 

network protocols. See the status line for each protocol on the

 

configuration page for more information.

 

I/O Card Not Ready: There is a problem with the print server

 

or its configuration.

 

Note

 

If the print server is not ready, an error code and message

 

appears. See Error messages.

 

 

Model Number

The HP JetDirect print server’s model number (for example,

 

J6035A).

 

 

Hardware Address

The 12-digit hexadecimal network hardware (MAC) address of

 

the print server that is installed in the printer or device. The

 

manufacturer assigns this address.

 

 

Firmware Version

The firmware revision number of the print server that is

 

currently installed in the printer. The format is X.NN.NN,

 

where X is a letter that depends on the HP JetDirect print

 

server model.

 

 

Port Select

The LAN port on the print server that has been detected for

 

use:

 

None: The print server is not connected to the network.

 

RJ-45:The RJ-45 network port is connected.

 

 

Port Config

The link configuration of the RJ-45 LAN port on the print

 

server:

 

10BASE-T HALF: 10 Mbps, half-duplex

 

10BASE-T FULL: 10 Mbps, full-duplex

 

100TX HALF: 100 Mbps, half-duplex

 

100TX FULL: 100 Mbps, full-duplex

 

Unknown: The print server is in an initialization state.

 

Disconnected: A network connection has not been detected.

 

Check the network cables.

EN

Understanding the print server configuration page 169

Page 171
Image 171
HP 1200 manual General HP JetDirect information, Message Description