Enhancements
Release M.10.32 Enhancements
■The
■The <password> parameter is the clear ASCII text string or
You can enter a manager, operator, or 802.1X
After you enter the complete command syntax, the password is set. You are not prompted to enter the password a second time.
This command enhancement allows you to configure manager, operator, and 802.1X
Release M.10.32 Enhancements
Release M.10.32 includes the following enhancement:
■Enhancement (PR_1000376626) — Enhanced the CLI "qos
■Enhancement (PR_1000401306) — Reload "IN/AT" special enhancement.
Scheduled Reload
Additional parameters have been added to the reload command to allow for a scheduled reboot of the switch via the CLI. The scheduled reload feature supports the following capabilities:
It removes the requirement to physically reboot the switch at inconvenient times (for example, at 1:00 in the morning). Instead, a reload at 1:00 mm/dd command can be executed (where mm/
ddis the date the switch is scheduled to reboot). It provides a safety net in situations where a change is made from a remote location to the running config that inadvertently causes loss of management access. For example, a newly configured ACL might deny access to the switch from the management station’s IP address such that the telnet session ceases to function. Scheduling a reload after command (timed to execute after the necessary configuration work is completed) will ensure that the switch will reboot automatically. Assuming the ACL changes were not saved to the startup config, telnet access will then be restored. If the ACL work is completed successfully, with no loss of access, the scheduled reboot can be cancelled with the reload cancel command.
Examples:
To schedule a reload in 15 minutes:
ProCurve# reload after 15
101