Software Fixes in Release M.08.51 - M.10.72

Release M.10.39

Release M.10.39

Problems Resolved in Release M.10.39

■Enhancement (PR_1000428213) — This software enhancement adds the ability to configure a secondary authentication method to be used when the RADIUS server is unavailable for the primary port-access method.

■Enhancement (PR_1000415155) — The ARP age timer was enhanced from the previous limit of 240 minutes to allow for configuration of values up to 1440 minutes (24 hours) or "infinite" (99,999,999 seconds or 3.2 years).

■Web UI (PR_1000414459) — During configuration of the GVRP Mode via the web interface (Configuration -> VLAN Configuration -> GVRP Mode), the port list does not show the last three port entries.

Release M.10.40

Problems Resolved in Release M.10.40

■Web UI (PR_1000380278) — The switch may periodically require reboot in order for the Web UI authentication page to load.

■CLI (PR_1000438486) — When using the port-accessmac-basedCLI command, the client MAC address is sent, in lower case, as the username to the RADIUS server. This fix adds an option so that the MAC address is in uppercase when sent to the RADIUS server. This fix adds additional parameters to the CLI command to support this: "aaa port-access mac-based addr-format".

Release M.10.41

Problems Resolved in Release M.10.41

■ARP Protection (PR_1000438129) — ARP and ARP protection data may not display correctly following CLI or SNMP status query.

■802.1x (PR_1000446227) — Switch 802.1X authentication running over PAP does not work if RADIUS message authenticator attribute is required.

■LACP/MSTP (PR_1000436184) — When a trunk comes up, only those physical ports that are not in the trunk negotiation state at the time become unblocked. Therefore, using multiple LACP trunks with MSTP may cause loss of network connectivity.

■AAA/CLI (PR_1000445886) — This changes the syntax of 'aaa authentication <port-access mac-based web-based>' commands which were previously added in PR_1000438486.

173