Enhancements

Release M.10.66 Enhancements

ProCurve(config)# logging priority-descr severe-pri

Figure 30. Example of the Logging Command with a Priority Description

Note

A notification is sent to the SNMP agent if there are any changes to the syslog parameters either through the CLI or with SNMP.

Command Differences for the ProCurve Series 2600/2800/3400cl/6400cl Switches

CLI Commands. The ProCurve series 2600/2800/3400cl/6400cl switches do not have the following CLI logging commands:

•logging severity

•logging system-module

SNMP Commands. The ProCurve series 2600/2800/3400cl/6400cl switches do not support the following SNMP objects:

•hpicfSyslogPrioritySeverity

•hpicfSyslogSystemModule

Operating Notes

■Duplicate IP addresses are not stored in the list of syslog servers.

■If the default severity value is in effect, all messages that have severities greater than the default value are passed to syslog. For example, if the default severity is “debug”, all messages that have severities greater than debug are passed to syslog.

■There is a limit of six syslog servers. All syslog servers are sent the same messages using the same filter parameters.

■An error is generated for an attempt to add more than six syslog servers.

142