Software Fixes in Release M.08.51 - M.10.72
Release M.08.61
■
■
■
■
■
■
■
2.In show CDP the Yes is changed to Yes,(Receive Only).
CLI (PR_1000192677) — Show
Console/TELNET (PR_1000195647) — When a console or TELNET session hangs, issuing the 'kill' command also hangs.
Crash (PR_1000193582) — Software Exception when clicking on the Identity Tab of a Member Switch in the Web user interface. The switch may crash with a message similar to:
Software exception at http_state.c:1138 in 'mHttpCtrl' TaskID = 0x1722cf8.
Crash (PR_1000196129) — Removing the J8434A module (10Gigabit) creates configuration problems and sometimes causes the switch to crash.
Crash (PR_1000199535) — Sometimes the command show
Crash (PR_1000201614) — When the switch is set with a
Crash (PR_1000204782) — Bus error when copying a configuration to the switch. The switch may crash with a message similar to:
Bus error: HW Addr=0x594f5531 IP=0x004ff8a8 Task='mftTask' Task
ID=0x126eba0 fp: 0x00000000 sp:0x0126e7d0 lr:0x001e655c.
■IP Addmgr (PR_1000200338) —
■
■
■
■
■
■
■
MIB (PR_1000206519) — The RFC 3636 MIB implemented is not correct.
Open VLAN (PR_1000210932) — Open VLAN mode (Unauth VLAN) does not work with any
Port toggle (PR_1000216940) — 10 Gigabit, CX4 port toggles (that is, Link up, Link down, and so on).
QOS (PR_1000200746) — Configure a
QOS (PR_1000213489) — The command show QOS resources displays blank information for the 10 Gigabit module.
SNMP (PR_1000196170) — Traps are not buffered before the IP stack is initialized, causing the possibility of missing some traps generated during startup.
Syslog (PR_1000215699) —
146