Software Fixes in Release M.08.51 - M.10.72

Release M.08.83

■RSTP (PR_1000300623) — Under some circumstances, the switch may allow packets to loop for an extended period of time.

Release M.08.83

Problems Resolved in Release M.08.83 (Not a general release)

■Crash (PR_1000297510) — When using the Web User Interface and the switch is set as commander for stacking, the switch may crash.

■Event Log/ARP (PR_1000293466) — Generic Link Up message not showing up and unnecessary flushing of ARP cache.

■KMS (PR_1000287934) — Some Key Management System (KMS) configuration commands have no effect.

■Setup (PR_1000301498) — Manual IP address can not be set using "setup" menu. (pre- release)

Release M.08.84

Problems Resolved in Release M.08.84 (Never released)

■CLI Enhancement (PR_1000306695) — Added "show tech transceivers" to display Serial Number information for installed mGBIC and 10Gig X2 transceivers. Allows removable transceiver serial numbers to be read without removal of the transceivers from the switch.

Release M.08.85

Problems Resolved in Release M.08.85 (Never released)

■RSTP (No PR) — Resolved broadcast storm caused by an unstable RSTP topology.

Release M.08.86

Problems Resolved in Release M.08.86

■CLI/DHCP (PR_1000286898) — Under some conditions, the CLI may freeze or lock up.

■IGMP (PR_1000301557) — Data-driven IGMP does not prevent flooding when no IP address exists on a VLAN.

■RSTP (PR_1000306227) — RSTP TCNs cause high CPU utilization and slow software based routing.

154