Software Fixes in Release M.08.51 - M.10.72

Release M.10.42

■SCP (PR_1000428142) — The switch does not exit a secure copy protocol (SCP) session properly.

Release M.10.42

No Problems Resolved in Release M.10.42 (Never Released)

Release M.10.43

Problems Resolved in Release M.10.43 (Never Released)

■CLI (PR_1000413734) — MDI/MDIX information shows "N/A" in the CLI output of the command show int brief. It should show either MDI or MDIX.

■Enhancement (PR_1000428642) — SNMP v2c describes two different notification-type PDUs: traps and informs. Prior to this software release, only the traps sub-type was supported. This enhancement adds support for informs. For more information, see “Release M.10.43 Enhancements” on page 126.

■Enhancement (PR_1000452407) — The Dynamic IP Lockdown feature was added for the 3400cl series switches. For more information, see “Release M.10.43 Enhancements” on page 126.

Release M.10.44

Problems Resolved in Release M.10.44 (Not a Public Release)

■Loop Protection (PR_1000447746) — Client-based AAA stops any packets with unau- thenticated source MAC-addresses, including BPDU's and loop-protect packets, creating loops that can be hard to detect.

■Crash (PR_1000456340) — The switch may crash with a message similar to the following.

No message buffers : alloc_free.c:435

■OSPF (PR_1000453794) — Removing an IP address from a multinetted VLAN, or removing the entire VLAN, causes the switch to stop seeing it's neighbors "Hello" packets, and, ultimately, lose the OSPF adjacency.

■Boot Image (PR_1000451000) boot image. Issuing a reload after image.

—Canceling boot system flash <pri sec> sets the default canceling causes the switch to boot into the canceled flash

174