Printer control panel messages (continued)
Message | Description | Recommended action | |
|
|
| |
DENSITY SENSOR | A density sensor out of range error | The density sensor may be | |
OUT OF RANGE | was detected during a color | dirty. Inspect and clean the | |
alternates with | calibration. | sensor (see “Cleaning the toner | |
CLEAN |
|
| density sensor” on page 149 |
DENSITY SENSOR |
| for cleaning instructions). | |
|
| ||
|
|
| |
DRUM ERROR | An error has been detected with a | Replace the print drum kit. | |
REPLACE KIT | component of the print drum kit. |
| |
|
|
| |
DRUM LIFE LOW | The imaging drum is near the end of | Order a replacement drum kit, | |
ORDER KIT | its expected life. | and continue printing. See | |
|
|
| “Printer supplies and |
|
|
| accessories” on page 31. |
|
|
| |
DRUM LIFE OUT | The imaging drum has reached the | Replace the drum kit. | |
REPLACE KIT | end of its expected life. See “Printer |
| |
|
| supplies and accessories” on |
|
|
| page 31. |
|
|
|
| |
DUPLEX ERROR | An error has occurred in the duplex | Verify that the duplex printing | |
CHECK DUPLEXER | printing accessory. | accessory is correctly installed. | |
|
|
| |
EIO DISK X | The EIO disk is not working | Remove the EIO disk from the | |
NOT FUNCTIONAL | correctly. | slot indicated. Call HP Support. | |
|
|
|
|
EIO X |
| The EIO device in slot X is | No action required. |
INITIALIZING YYY | initializing. The YYY value will |
| |
alternates with | increment every 10 seconds during |
| |
DO NOT |
| this process. |
|
POWER OFF |
|
| |
|
|
|
|
EIO X |
| The EIO slot specified does not | No action required. |
NOT FUNCTIONAL | have a card installed or is not |
| |
|
| functional. |
|
|
|
| |
EIO X DISK | The disk accessory is initializing. | No action required. | |
SPINNING UP | The first parameter is the accessory |
| |
|
| slot number for this accessory card. |
|
|
|
| |
EVENT LOG | SHOW EVENT LOG was selected | No action required. | |
EMPTY |
| from the Information Menu, but the |
|
|
| event log has no entries. |
|
|
|
| |
FLASH DIMM X | The new Flash DIMM installed in | No action required. | |
INITIALIZING | slot X is initializing. |
| |
alternates with |
|
| |
DO NOT POWER OFF |
|
| |
|
|
|
|
[FS | ] DEVICE | The hard disk, flash DIMM, or RAM | Remove the flash DIMM and |
FAILURE |
| disk had a critical failure and no | replace it with a new one. |
|
| longer can be used. |
|
|
|
|
|
EN
Chapter 8 155
