HP 4550DN, 4550HDN, 4550N 135

Configuring TCP/IP parameters

You can use the printer control panel to configure the following

TCP/IP parameters:

●usage of the BOOTP file for configuration parameters (the default is to use the BOOTP file)

●IP address (4 bytes)

●subnet mask (4 bytes)

●default gateway (4 bytes)

●TCP/IP connection timeout (in seconds)

Note	Do not disable BOOTP if you will be using RARP or DHCP to configure
	TCP/IP parameters.

To configure TCP/IP parameters from the printer control panel

1 Press MENU until HP EIO 1 or 2 MENU displays.

2Press ITEM until CFG NETWORK=NO * displays.

3Press VALUE until CFG NETWORK=YES displays.

4Press SELECT once. CFG NETWORK=YES * displays.

5Press ITEM until CFG TCP/IP=NO * displays.

6Press VALUE once. CFG TCP/IP=YES displays.

7Press SELECT once. CFG TCP/IP=YES * displays.

8Press ITEM to configure TCP/IP parameters manually.

BOOTP=YES * displays.

Chapter 6 135