Printer response problems
No display message
Cause | Solution |
|
|
The printer’s power switch (standby button) is | Verify that the printer is on. Fans may run while |
in the standby position. | the printer is in standby mode (off). |
|
|
The printer’s memory DIMMs are defective or | Verify that the printer’s memory DIMMs are |
installed incorrectly. | correctly installed and are not defective. See |
| |
|
|
The power cord is not firmly plugged into both | Turn off the printer and then disconnect and |
the printer and the power receptacle. | reconnect the power cord. Turn the printer |
| back on. |
|
|
The line voltage is incorrect for the printer | Connect the printer to a proper voltage source, |
power configuration. | as specified on the Power Rating Label on the |
| back of the printer. |
|
|
The power cord is damaged or excessively | Replace the power cord. |
worn. |
|
|
|
The power source receptacle is not working | Connect the printer to a different power |
correctly. | receptacle. |
|
|
EN
Chapter 9 189