HP 480-0005-00-15 manual 10Cables Supported, RJ-45 Cables, Cable Usage, All units

Chapter 2: Hardware Components

Cables

The cables listed in Table 2-10are required to connect a Tenor CMS to various interfaces. Contact Quintum for ordering information, if necessary.

Table 2-10Cables Supported

Cable	Usage
RJ-48 to RJ-48 Crossover Cable (this cable is red	All units
if provided by Quintum)	T1/E1 connection to Line Side (PBX) inter-
	face.
RJ-48 to RJ-48 Straight Through cable (this cable	All units
is green if provided by Quintum)	T1/E1 connection to Trunk Side (PSTN) inter-
	face.
	T1/E1 connection to external CSU.
RJ-45 Ethernet cable (grey)	All units
	Connection to Ethernet LAN 10/100.
DB-9 Male to DB-9 Female Null Modem Cable	All units
(for use with System Controller)	Connection to PC’s asynchronous console
	port.
DB-9 Serial RS-232 (for use with CPU)	All units
	Connection to PC’s asynchronous console
	port.
Detachable (IEC) AC Power Supply Cord (for AC	All units
units only)	Connection to AC power jack.

RJ-45 Cables

RJ-45 cable connector pinouts are given in this section to help you identify the proper connector to accommo- date your specific networking requirements. The RJ-45 (ISO 8877) connector is the EIA/TIA standard for Unshielded Twisted Pair (UTP) cable; the wiring color codes are UTP Standard Coloring. The pin order is shown in Figure 2-27.

	Figure 2-27RJ-45 Pin Order
		Side View
8				1
			Top View

1 8

P/N 480-0005-00-15 2-31