HP 480-0005-00-15 manual Rear with AC power, Power Inlet

Chapter 2: Hardware Components

•Air Filter. The Air Filter is accessible by opening the lower front panel. You do not have to turn off the chassis. For cleaning, see Chapter 8: Diagnostics/Maintenance.

•Chassis LEDs. The LEDs are indicators as to the status of the four DC outputs of the power supplies. When these are lit, they indicate the respective voltages are being output from the power supplies. When unlit, the voltage is not being supplied. See Chapter 8: Diagnostics/Maintenance for more information.

•On/Off Power: A switch to turn power on and off.

Rear (with AC power)

NOTE: For pictorial purposes, Figure 2-2 is shown with 2 DS1 cards and the CPU Card.

Figure 2-2Tenor CMS Rear View - AC unit

Power Inlet

Link	TX/RX
	1			1
	2	1
	3
	4
		2		2
	1
		3		3
	2
		4		4
	3
		1		1
	4
10/100		2		2
Ethernet
		3		3
Console		4		4
	10/100		10/100
	Ethernet		Ethernet
	Link	TX/RX	Link	TX/RX
Off	On
	1
	2
	3
	4
Config
	Link	TX/RX	Link	TX/RX

CPU DS1 DS1

10

A

M

P

© Copyright 2001 Quintum Technologies Inc.

100-240VAC

50-60Hz

Air Exhaust

WAN Card Slots

Earth Ground Stud Label Ground Strap Port

•WAN Card Slots. The rear of the T1, E1, or DS1 WAN cards (the transition modules), is used for net- work connection. The quantity will vary depending upon the number of WAN cards you have inserted.

•Power Inlet. Inlet for which you insert the supplied AC power cord. The unit requires a 110-240 VAC.

•Earth Ground Stud. A Ground Stud is provided to connect to earth ground.

•Ground Strap Port. A ground connection is provided for ESD protection.

2-4 P/N 480-0005-00-15