HP 480-0005-00-15 manual Connect to Ethernet LAN with CPU Card, 5Connect to Ethernet Hub/Switch

Chapter 3: Installation

Connect to Ethernet LAN (with CPU Card)

You can use these instructions for general connection purposes only. The Ethernet hub/switch manufacturer documentation should provide specific instructions for connection to another device, such as Tenor CMS. One Ethernet port is enabled; the other three ports are not used.

NOTE: For illustrations purposes, the unit is shown with CMS240 (2 slot) with AC power.

Figure 3-5Connect to Ethernet Hub/Switch

	DS1		Link TX/RX	Link TX/RX	10/100 Ethernet	8	7		6	5	4	3	2			1
1	CPU	Config	Off On 1 2 34			Console	Ethernet	10/100					4	3	26	15	Link
0																	TX/RX
									4	3	2	1	2 8	7

Chassis Rear (AC view)

CPU	Config		Off On	Console	Ethernet	10/100						4	3	2 6	1 5	Link
		1 2 3 4					4	3	2	1	2	8	7			TX/RX

Data

Network

Ethernet Hub/Switch

1.Plug one end of the grey RJ-45 ethernet cable into one of the ports on the CPU rear transition module labeled 10/100 Ethernet.

2.Plug the other end of the cable into the Ethernet hub/switch port. If a custom cable or adapter is required,

see Chapter 2: Hardware Components for Ethernet RJ-45 10/100.

3-8 P/N 480-0005-00-15