HP 480-0005-00-15 manual Connect to PC Console with System Controller, 6Connect to PC Com

Chapter 3: Installation

Connect to PC Console (with System Controller)

You will need to connect the Tenor CMS chassis to your workstation’s serial port via RS-232 connection. (This connection will be used when you assign an IP address to the chassis. The instructions below assume you are connecting to a PC).

NOTE: For illustration purposes, the CMS (14 Slot) AC unit is shown

Figure 3-6Connect to PC Com

QUINTUM	Tenor CMS
	QUINTUM	QUINTUM

Chassis Front

10/100

Ethernet

DB-9

Console

RST

ABT

BFL CPU

CPCI PCI

.295 .531

TM

NOTE: You must use a null modem cable with a DB-9 male connector (see section Chapter 2: Hardware Components for pinouts) to connect the System Controller card to a PC as follows:

1.Insert the male end of the DB-9 cable (yellow cable if provided by Quintum) into the System Controller card’s port labeled Console. (See Chapter 2: Hardware Components for RS-232 connector pinouts.)

2.Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC documentation for more information about this port).

P/N 480-0005-00-15 3-9