Chapter 3: Installation

Install Power Cord Strain Relief (AC only)

NOTE: Instructions for using the Power Cord Strain Relief for DC power are included in the previous two sections.

The Strain Relief Mount enables you to connect the power cord strain relief to the unit. A power cord strain relief is a plastic device designed to avoid accidental power down of the Tenor CMS (i.e., if the power cord is accidentally pulled, the strain relief will relieve pressure put on the cord.)

Install the strain relief as follows:

1.Loop the strain relief’s long plastic piece around the power cord and insert the end of the plastic rivet through the hole at the opposite end (to create a “clamp”). See Figure 3-16.

Figure 3-16Loop the strain relief around the power cord

Rivet

Loop long piece around cord.

 

Power cord

2.Push the rivet into the Strain Relief Mount at the rear of the unit. See Figure 3-17.

Figure 3-17Insert clamp in Strain Relief Mount

Strain Relief Mount

AC Power Plug

 

DS1

 

Link TX/RX

Link TX/RX

10/100 Ethernet

8

7

 

6

5

4

3

2

 

 

1

 

1

CPU

Config

Off

 

 

Console

Ethernet

10/100

 

 

 

 

4

3

26

15

Link

0

 

 

 

 

 

 

On 1 2 3 4

 

 

 

 

 

 

 

 

TX/RX

 

 

 

4

3

2

1

2

7

 

 

 

8

P/N 480-0005-00-15

3-16

Page 79
Image 79
HP 480-0005-00-15 manual Install Power Cord Strain Relief AC only, Rivet