HP 480-0005-00-15 manual Connect to PC Console with CPU, 7Connect to PC Com

Chapter 3: Installation

Connect to PC Console (with CPU)

You will need to connect the Tenor CMS chassis to your PC’s serial port via RS-232 connection. (This con- nection will be used when you assign an IP address to the chassis. For the instructions below, it is assumed you are connecting to a PC.)

NOTE: For illustration purposes, the CMS240 (2 slot) AC unit is shown.

Figure 3-7Connect to PC Com

	DS1		Link TX/RX	Link TX/RX	10/100 Ethernet	8	7		6	5	4	3	2			1
1	CPU	Config	Off On 1 2 34			Console	Ethernet	10/100					4	3	26	15	Link
0																	TX/RX
									4	3	2	1	2 8	7

Chassis Rear (AC

CPU Config Off On 1 2 3 4 Console 10/100 Ethernet

4 3 2

	4	3	2	1	Link
1	8 2	7	6	5	TX/RX

DB-9

NOTE: You must use a DB-9 Serial RS-232 cable with a DB-9 male connector (see section Chapter 2: Hardware Components for pinouts) to connect the chassis to a PC.

1.Insert the male end of the DB-9 cable (grey cable if provided by Quintum) into the CPU card’s rear port labeled Console. (See Chapter 2: Hardware Components for serial RS-232 connector pinouts.)

2.Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC documentation for more information about this port).

3-10 P/N 480-0005-00-15