HP 480-0005-00-15 manual 2List of Valid Alarms, Severity Alarm Description

Chapter 7: System Alarms

Valid Alarms

The following is a list of all alarm descriptions (text that appears in the Alarm Description field) for all possi- ble alarms the system can generate. In the generated alarm list, the alarm description appears as part of the Description field.

	Table 7-2List of Valid Alarms
Severity	Alarm Description
(appears as		Definition
part of severity	(text appears in desc field)
field)
Critical	Loss of Framing (Red Alarm)	Signal is not being transmitted; there is no layer 1 syn-
		chronization.
Critical	Remote Alarm indication (Yellow	Tenor CMS is receiving a yellow alarm signal from the
	Alarm)	network.
Critical	Loss of signal	A loss of signal (32 consecutive zeros) at least once dur-
		ing a 1 second period.
Critical	AIS Reception (Blue Alarm)	Alarm Indication Signal. An all ones condition used to
		alert the Tenor CMS that its incoming signal (or frame)
		has been lost.
Critical	Layer 2 Down	Indicates that Layer 2 protocol is down.
Critical	Ethernet Disconnected	Ethernet cable has been disconnected from the System
		Controller or CPU Card, or Ethernet connectivity has
		been lost. No new VoIP calls will be made and existing
		PSTN calls will be switched to the PSTN.
Critical	Call Handler not registered with Gate-	The Call Handler process cannot be registered with the
	keeper	Gatekeeper.
Critical	Critical Software Error	A software error has occurred that affects the operability
		of the complete system.
Critical	Tenor CMS Chassis reset	The chassis has reset.
Critical	Card Temperature out of operating range	A card’s temperature has reached the maximum operat-
		ing range. The cause may be a fan failure.
Critical	Card reset	This alarm is viewable upon power up. If this alarm con-
		tinues, there may be a problem with the card.
Critical	Primary Digital Interface Clock Loss	Clock source has been lost for T1 lines. The unit will
		automatically switch to the secondary digital interface
		clock source.
Critical	Secondary Digital Interface Clock Loss	All clock sources have been lost, both primary and sec-
		ondary. Check the T1 lines for the possible cause.

7-4 P/N 480-0005-00-15