Exit Roller Assembly

1Remove Printer Covers.

2Grasp both tabs at the lower ends of the Exit Roller bushings and pull inward. This will release the tabs from the printer chassis (Figure 6-8, callout 1).

3Rotate the tabs 90 degrees, clear of the printer chassis (Figure 6-8, callout 2).

4Lift the roller out.

2

1

Figure 6-8Exit Roller removal

To reinstall

The end of the Exit Roller that has a gear attached must fit into the gear train. Although it is possible to reinstall the Exit Roller so that the gear end is on the opposite side of the printer, this placement would cause paper path problems.

EN

Internal assemblies 79