HP 6L pro, 6L Gold manual Installing memory cards Dram, Push it firmly into the printer

Installing memory cards (DRAM)

1

Note

The HP LaserJet 6L Pro does not support memory upgrades.

	1	Unplug the power cord from the printer. You should not install a
		memory card while the printer is in SleepMode.
2	2	Open the Printer Door, remove the toner cartridge, and close the
		Printer Door. Protect the toner cartridge from light while you are
		working on the printer.
	3	Remove any paper in the paper tray. Gently tip the printer onto its
		side so that the memory cover is on top as shown in Figure 3.
	4	Remove the Memory Expansion Cover by carefully pulling the tab
		out and away from the printer in a gentle rocking motion.
3	5	Align the memory card with the corner notch so it is positioned as in
		Figure 4. Push it firmly into the printer
	Replace the Memory Expansion Cover, set the printer upright, reinstall
	the toner cartridge, reinsert paper, and reconnect to the power source.
	Print a self-test page (see Chapter 3) to check that the printer
	recognizes the additional memory you have added. Your Total Memory
	in the “Printer Information” section will show the new MB total.
4	1 MB card		2 MB total
	2 MB card		3 MB total
	4 MB card		5 MB total
	8 MB card		9 MB total

5

72 Removal and replacement EN